How to water flowering plants

These plants like a consistent rhythm, neither dry nor wet for too long. Most common flowering houseplants fall into this category.

Care instructions

1. Let the top layer of soil dry slightly.
   Check moisture about 1 inch (2–3 cm) deep. If the soil feels dry at that depth, it’s time to water. These plants like consistency but dislike soggy roots.

2. Water evenly and drain off excess.
   Give the plant a good soak, allowing water to run through the drainage holes. Be sure to empty any standing water from the saucer or outer pot.

3. Monitor humidity and indoor temperature.
   These plants may need more frequent watering during warm, dry periods or while actively flowering.

4. Ease off during the rest period.
   Most flowering plants benefit from slightly reduced watering in fall and winter, especially if growth slows.

Watering methods

Water over the soil

1. Pour water over the soil, using, for example, a watering can or put the plant directly under a tap

2. Continue adding water to the pot until it starts to run out from the drainage holes

3. If you have a tray under the pot when watering, make sure you remove all the collected water afterwards - never let your plant sit in water

4. If you watered under a tap make sure that water has stopped running out from the bottom before putting it back

Bottom watering

1. Fill the plant tray with water

2. Make sure the soil is in contact with the water on the tray

3. Wait for about 10 minutes

4. Feel the soil to see if it absorbed enough water > if the soil is moist throughout, remove any excess water from the tray

5. If it’s still dry > add more water to the tray

6. Wait 20 more minutes before removing the excess

Bottom watering will not wash away salts and other minerals from the soil, so make sure to also give water over the soil every now and then.

Water bath

1. Fill a bucket or any other vessel with lukewarm water

2. Lower the whole pot down in the water, stop where the stem of the plant starts. Make sure all of the soil is under water

3. The water will now start to bubble - wait until it stopped

4. Lift the pot up and let the excess drain off

5. Put your plant back in the cachepot or on the tray

6. After 1 hour, check that your plant isn’t standing in water, if it is it might get overwatered and rot