Planta
Tillbaka till Pests, diseases and problems 🇺🇸

Still new to plant parenting! My variegated monstera standleyana has… | Pests, diseases and problems 🇺🇸 | Planta-community

Olivia M

Still new to plant parenting! My variegated monstera standleyana has one lower leaf that turned yellow over the weekend. For the past few weeks it has been showing new growth like crazy considering it was propagating in water just a couple months ago. I came into work today and now the edge of the yellow leaf is browning but the little leaf on the left just popped out today. This pot doesn’t have a drainage hole so I know that is an immediate issue but it’s just weird that everything but that one leaf is doing great. Any ideas or recommendations?

Bilaga 1 av 2Bilaga 2 av 2
1 gilla 10 kommentarer

10 kommentarer

  1. Wolfen 🐺

    It may just be because it looks below the soil line, and is older. I'd just remove it. And inspect for any pests. I wouldn't be too worried if it's popping new growth

    2 gillningar
    • Olivia M

      thank you!

      0 gillningar
  2. All_things_plants

    It is just an old leaf I think

    1 gilla
    • Olivia M

      thank you!!

      0 gillningar
  3. SueB

    Plants will often shed old leaves especially as in this case a new leaf is growing. It would rather put the resources into the new growth.

    3 gillningar
    • Olivia M

      makes sense! thanks!!

      0 gillningar
  4. MoMo

    But also get a pot with a drainage hole… I beg you 😬

    1 gilla
    • Olivia M

      I knowwwww I don’t know why this really expensive plant store even sells them to be honest. I figured with it starting off as a propagation I could buy myself some time 🤦‍♀️

      1 gilla
    • MoMo

      I’ve been caught by it before too a never ends well after a while and you end up having to fix the roots! Though weirdly I have one rubber plant that only likes its horrible original pot with no drainage. 🤷‍♀️

      0 gillningar
  5. Phil

    You could do the pot in a pot method. Or drill a hole in the bottom. I’ve done it many times. But special drill bit needed for ceramic.

    0 gillningar