I bought this mini orchid and it’s in moss. The roots look kind of bad, should I repot it in orchid bark?
I bought this mini orchid and it’s in moss. The roots look kind of bad, should I repot it in orchid bark?
Actually those roots look pretty happy. They can sometimes look like that, but over all they look like a happy little guy. Just make sure to water them with lukewarm water and avoid water getting into the center of the leaves.
2 gillningarUnless the leaves start looking worse, I would wait until the blooms fall to repot it
1 gilla
Roots look to be in reasonable shape for a newly acquired plant. However it’s in sphagnum and that’s not a great setup for most home growers. I would repot once it is finished blooming. The flowers typically last one to three months. I would cut the inflorescence back to the base of the plant once the final bloom drops. There is a way to try for a second bloom but in the following year flowers tend to be fewer in number and sometimes smaller. Flowering is very taxing process for the plants. When you get ready to repot, I would first give it a good soak as things are easier when hydrated. Take the orchid out of the pot and gently remove the media from the roots. Try get it all, but it’s fine if you have to leave some so you don’t damage the roots. And don’t worry if you damage some roots. It isn’t great but it happens. Just try to minimize as much as possible. Examine the roots for health and pests. Trim off any dead or dying roots. Dead roots are papery or mushy, black or brown. Healthy roots are firm and green when wet, silvery when dry. Deeper into the media you may encounter pale yellow roots. It just means they haven’t been exposed to light. They are fine as long as they are firm. I would leave any wrinkled roots as long as they are firm. Use an orchid pot with additional ventilation. They are typically clear so you can monitor root development, and have ventilation holes on the sides of the pot. If you don’t have one, you can add holes to a growers pot or any other plastic pot you have on hand. Size the pot so that the roots just fit in the pot. They like a tight fit. To minimize transplant shock, use a similar mix to what it currently is in. If your plant is in sphagnum, I would repot using a mix of 50% sphagnum 50% bark. That will allow moisture to hang around long enough for the roots to take in what they want without cutting off air circulation. If you are a heavy waterer you can reduce the amount of sphagnum in your mix. My preference is straight bark. The key is a loose airy mix that will allow the roots to dry between waterings. Regardless of what mix you use, gently work it around the roots. I use an old chopstick for the job. The goal is to firmly seat the plant in the pot without packing the media. You want an airy mix that allows the roots to grab the water they want and then dry out. When I water, I soak the pot for 10-15 minutes. Wait until the media dries out (look for silver roots) before watering again. For my setup, that works out to roughly once a week. Each time I water, I use fertilizer at 1/4 strength. Once a month flush with pure water to reduce salt buildup (this is especially important if you are using synthetic fertilizer).
1 gilla