---
title: "Hi everyone! My rubber plant has lost all its leaves at the bottom -…"
description: "Hi everyone! My rubber plant has lost all its leaves at the bottom - any suggestions? I was reading I could notch it a couples times. Or do I just cut it? I’m…"
url: "https://getplanta.com/community/lZ7uAE3pQ86jnFGxrCwLrg/lQGYbCKfB59G8YQw1ufsID?language=da"
community: "Anything about plants"
author: "AspiringPlantMama"
published: "2025-03-18T04:13:45.111951Z"
language: "en"
image: "https://images.getplanta.com/v1/resize/u--g7o3GhJMFawT2_FbqBDf0SZrRoVuBm52jvB_fIPk/WO9ypKfZQX-6HbWOvewqPw.webp?size=large"
---

[Fællesskab](https://getplanta.com/community.md?language=da) / [Anything about plants](https://getplanta.com/community/lZ7uAE3pQ86jnFGxrCwLrg.md?language=da)

# Hi everyone! My rubber plant has lost all its leaves at the bottom -…

_Opslået af AspiringPlantMama den 2025-03-18_

Hi everyone! My rubber plant has lost all its leaves at the bottom - any suggestions? I was reading I could notch it a couples times. Or do I just cut it? I’m worried it won’t grow roots with that many leaves. Thanks in advance!

![Vedhæftet fil 1 af 1](https://images.getplanta.com/v1/resize/u--g7o3GhJMFawT2_FbqBDf0SZrRoVuBm52jvB_fIPk/WO9ypKfZQX-6HbWOvewqPw.webp?size=large)

## 7 kommentarer

### c.cat kommenterede den 2025-03-18

maybe look into keikei cloning paste? ive never used it but i think a lot of people on here use and like it

### KJM kommenterede den 2025-03-18

I've had my rubber plant for years. And I've topped it at least once maybe twice. Cut the top take off a few leaves from the bottom and replant it in the same pot and your bottom stem should also grow new branches.

![Vedhæftet fil 1 af 1](https://images.getplanta.com/v1/resize/ZnK-DEQES8ehqUKLJetaIR6rKdy5ZmUgQub0mb3GhWc/PlddbiiEQsWZD_HyFPsmug.webp?size=large)

#### AspiringPlantMama svarede den 2025-03-19

Thanks! Good to know. When you top it do you take the entire top off and leave a stem without leaves?

### KJM kommenterede den 2025-03-18

I think I might top it again this spring

![Vedhæftet fil 1 af 1](https://images.getplanta.com/v1/resize/ZnK-DEQES8ehqUKLJetaIR6rKdy5ZmUgQub0mb3GhWc/_T6sMvgnQzW7uwNo4h_iWw.webp?size=large)

#### KJM svarede den 2025-03-19

You can take it down as far as you want. There do not have to be leaves on the bottom but there does have to be on the top. At a minimum you should have at least three leaves on the top and then two or three nodes that will go into the soil where it will root. Depending on how much you want to take off you could actually root a middle section leaving a couple leaves on the top and taking the leaves off where it goes into the soil. That's only if you have enough stem and you want to take it down low enough. It looks like your tree might be 4 to 5 ft tall so I think I would take it down halfway. Of course you don't have to take it down that low and it would still be fine.

### KJM kommenterede den 2025-03-19

Now that I've read that let me clarify. You do not have to have any leaves on the trunk that is left after you make the cut. The pieces that you're propagating need to have a couple leaves.

### AspiringPlantMama kommenterede den 2025-03-19

This is so helpful - thank you so much!

---

_Planta-fællesskabet (https://getplanta.com). Alle kan læse med. For at slå op, kommentere og like, hent Planta-appen: https://getplanta.com/download_